Posted by Dan (66.122.81.186) on February 05, 2007 at 18:20:04:
In Reply to: Re: Can you profile a sheer cross section ? posted by Holin Chang on February 04, 2007 at 21:34:43:
: Should the jig and the mounted sample be sent to you if we provide a sample with a special bevel angle? Is our jig compatible with your's? They said we had cooperated on special bevel sample with you.
We have used customer supplied blocks in the past and would return them with your report after the analysis is done. If you have round beveling blocks with no more than a 1.25 inch diameter, we would be able to use them on our beveling devices and probe stations.
If you still plan on needing a 100um deep profile within a 100um area, you will actually need something a little steeper than 45 degrees. Or you will need to find larger areas in which to run the profiles. Using such a steep angle will not necessarily provide any more resolution than a perpendicular bevel would.